I like using a good quality wood glue when attaching wood to other pieces of wood.
Diy tongue and groove barn door.
We used this one which i was estatic to find because it was about 5 per board.
Diy barn doors step 1 selecting the material.
Face nail this board to the back of the frame.
Hammer the tongue into the groove for a tight fit.
You ll need a table or horses and a second person to help to assemble which is the most difficult.
Grab a rubber mallet and scrap piece of wood.
The center is the only spot that has glue all the way thru touching both sides of groove and tongue.
10 pieces of tongue and groove pine 8 ft tall or however tall you want it it comes in 6 ft 8 ft and 12 ft at home depot.
Materials for building a tongue and groove barn door.
With the right bracing a door made from tongue and groove wood is solid and will hold up over the years.
Liberally apply glue all across the bottom face of the tongue and groove board.
The next step to building the barn door was installing the rough sawn tongue and groove boards to the back of the face frame.
Lay all of your pine tongue and groove out.
For rustic applications recreation rooms barns shops or even boutiques build a tongue and groove door by bracing it diagonally.
This style of door is attractive and imparts a country feel to the surroundings reminiscent of farms and ranches.
We cut each 8 wide piece to our desired length 84 and then ran the end pieces through the table saw to remove the exposed tongue and the groove slots on each side of the door.
Coarse drywall screws 1 countersink bit.
I purchased mine at lowe s for 5 58 each and used 8 boards for the door 3 for the frame and 2 for the british brace arrow look so 13 total per door.
The tongue and groove boards not only look great but add a tremendous amount of strength to the overall piece.
This will be our anchor piece so we can install the rest of the tongue and groove 1 6 s.
I would purchase a few extra just in case you make a mistake.
Here is what we used to make our barn door.
I also like this board because it has a beadboard like pattern on one side.
For this i used screws and elmer s carpenter s wood glue max to attach the boards.
Again middle board is the only one that gets glue all the way thru.